dc.contributor.author
Shahgodari, Shirin
dc.contributor.author
Llorens Llacuna, Joan
dc.contributor.author
Labanda, Jordi
dc.date.accessioned
2025-12-06T19:20:58Z
dc.date.available
2025-12-06T19:20:58Z
dc.date.issued
2025-12-05T13:54:27Z
dc.date.issued
2025-12-05T13:54:27Z
dc.date.issued
2025-06-18
dc.date.issued
2025-12-05T13:54:27Z
dc.identifier
https://hdl.handle.net/2445/224719
dc.identifier.uri
http://hdl.handle.net/2445/224719
dc.description.abstract
This study examined total ammoniacal nitrogen (TAN) rejection by two reverse osmosis (RO) and two nanofiltration (NF) membranes as a function of pH for three ammonium salts to optimize conditions for a hybrid membrane system that can produce high-purity TAN streams suitable for reuse. The results showed that TAN rejection was significantly influenced by membrane type, feed pH, and the ammonium salt used. This study represents the first attempt to simulate real manure wastewater conditions typically found in pig manure. TAN rejection for (NH4)2SO4 and NH4HCO3 reached up to 95% at pH values below 7, with the SW30 membrane showing the highest performance (99.5%), attributed to effective size exclusion and electrostatic repulsion of SO42− and HCO3 ions. In contrast, lower rejection was observed for NH4Cl, particularly with the MPF-34 membrane, due to its higher molecular weight cut-off (MWCO), which diminishes both exclusion mechanisms. TAN rejection decreased markedly with increasing pH across the BW30, NF90, and MPF-34 membranes as the proportion of uncharged NH3 increased. The lowest rejection rates (<15%) were recorded at pH 11.5 for both NF membranes. These results reveal a notable shift in separation behavior, where NH3 permeation under alkaline conditions becomes dominant over the commonly reported NH4+ retention at low pH. This novel insight offers a new perspective for optimizing membrane-based ammonia recovery in systems simulating realistic manure wastewater conditions. TAN recovery was evaluated using a hybrid membrane system, where NF membranes operated at high pH promoted NH3 permeation, and the SW30 membrane at pH 6.5 enabled TAN rejection as (NH4)2SO4. This hybrid system insight offers a new perspective for optimizing membrane-based ammonia recovery in systems simulating realistic manure wastewater conditions. Based on NH3 permeation and membrane characteristics, the NF90 membrane was operated at pH 9.5, achieving a TAN recovery of 48.3%, with a TAN concentration of 11.7 g/L, corresponding to 0.9% nitrogen. In contrast, the MPF-34 membrane was operated at pH 11.5. The NF90–SW30 system also achieved a TAN recovery of 48.3%, yielding 11.7 g/L of TAN with a nitrogen content of 1.22%. These nitrogen concentrations indicate that both retentate streams are suitable for use as liquid fertilizers in the form of (NH4)2SO4. A preliminary economic assessment estimated the chemical consumption cost at 0.586 EUR/kg and 0.729 EUR/kg of (NH4)2SO4 produced for the NF90–SW30 andMPF-34–SW30 systems, respectively.
dc.format
application/pdf
dc.relation
Reproducció del document publicat a: https://doi.org/10.3390/polym17121696
dc.relation
Polymers, 2025, vol. 17
dc.relation
https://doi.org/10.3390/polym17121696
dc.rights
cc-by (c) Shirin Shahgodari et al., 2025
dc.rights
http://creativecommons.org/licenses/by/4.0/
dc.rights
info:eu-repo/semantics/openAccess
dc.subject
Membranes (Tecnologia)
dc.subject
Membranes (Technology)
dc.title
Study of Total Ammoniacal Nitrogen Recovery Using Polymeric Thin-Film Composite Membranes for Continuous Operation of a Hybrid Membrane System
dc.type
info:eu-repo/semantics/article
dc.type
info:eu-repo/semantics/publishedVersion