2026-04-14T03:25:31Zhttps://recercat.cat/oai/request

oai:recercat.cat:10256/229592026-03-14T00:09:13Zcom_2072_452955com_2072_2054col_2072_453061

Sensitivity analysis of a particle retention model and application to a pressurised sand bed filter for drip irrigation Pujol i Sagaró, Toni Duran i Ros, Miquel Betancur Gómez, Juan Diego Arbat Pujolràs, Gerard Cufí Aregay, Sílvia Pujol Planella, Joan Ramírez de Cartagena Bisbe, Francisco Puig Bargués, Jaume Regatge per degoteig Materials porosos Trickle irrigation Porous materials Filtres i filtració Filters and filtration Accurate model predictions are fundamental when designing porous media filters in drip irrigation systems that reduce both energy and water consumption. Many studies have focused on improving filter hydraulics under clean water conditions but further advances may require consideration of particle retention by the granular media. Rapid deep bed filtration models employ conservative equations and empirical correlations to determine the behaviour of particle depositions on the media. These models involve many input parameters, some of which have an inherent uncertainty range. Therefore, thorough model sensitivity analyses must be carried out prior to their use as predictors for the assessment of new filter designs. This paper applies both local and global (variance-based Sobol indices) sensitivity methods to a comprehensive particle retention model that is able to describe the main three stages of the filtration process. Uncertainty ranges of 15 input variables were defined. Three model outputs were analysed (flow particle concentration at the filter's outlet, mass of retained particles per unit area, and total pressure drop through the porous media) at different flow times. The results of the global sensitivity analysis indicated that the relevant model parameters vary depending on the filter stage. The rank of influential input variables also varied depending on the chosen output variable. The least absolute shrinkage and selection operator (LASSO) regression analysis method was also applied but the high non-linearity of the model reduced its predictive capacity in most of the situations analysed. Conclusions from the global sensitivity analysis were employed for model calibration with experimental data Open Access funding provided thanks to the CRUE-CSIC agreement with Elsevier 2023-06 info:eu-repo/semantics/article info:eu-repo/semantics/publishedVersion peer-reviewed http://hdl.handle.net/10256/22959 7256194 eng info:eu-repo/semantics/altIdentifier/doi/10.1016/j.biosystemseng.2023.04.006 info:eu-repo/semantics/altIdentifier/issn/1537-5110 info:eu-repo/semantics/altIdentifier/eissn/1537-5129 Reconeixement 4.0 Internacional http://creativecommons.org/licenses/by/4.0 info:eu-repo/semantics/openAccess 20 p. application/pdf Elsevier Biosystems Engineering, 2023, vol. 230, p. 51-70 Articles publicats (D-EMCI) Pujol i Sagaró, Toni Duran i Ros, Miquel Betancur Gómez, Juan Diego Arbat Pujolràs, Gerard Cufí Aregay, Sílvia Pujol Planella, Joan Ramírez de Cartagena Bisbe, Francisco Puig Bargués, Jaume 2023 Sensitivity analysis of a particle retention model and application to a pressurised sand bed filter for drip irrigation Biosystems Engineering 230 51 70