Abstract:
|
Plastic deformation can induce the austenite transformation to martensite in metastable austenitic stainless steels. To analyze this issue, a metastable austenitic stainless steel grade AISI 301 LN was studied in two different conditions, i.e. annealed and cold rolled. In the first case, the steel was fully austenitic, whereas after cold rolling a significant proportion of alpha’-martensite was present. High cycle fatigue tests at high stress ratios were carried out on specimens from both steel conditions. Several characterization techniques, including optical microscopy, X-ray diffraction and electron back scattered diffraction (EBSD), were used to detect and quantify the martensite. The results showed an increase on the fatigue life for the cold rolled specimens as compared to the annealed ones. This fact is related with the presence of martensite originated by cold rolling, which limited the amount of new martensite formed during fatigue tests. // La deformación plástica puede inducir a la transformación de la austenita a martensita en los aceros inoxidables austeníticos metaestables. Para analizar este hecho, el inoxidable austenítico metaestable grado AISI 301 LN fue estudiado en dos condiciones diferentes: recocido y laminado en frío. En el primer caso, el acero era completamente austenítico, mientras que después de la laminación presentaba un importante porcentaje de alfa’-martensita. Se realizaron
ensayos de fatiga de alto número de ciclos con una relación de esfuerzo elevada en probetas del acero en ambas condiciones. Se utilizaron diferentes técnicas de caracterización para detectar y cuantificar la martensita, como microscopía óptica, difracción de rayos-X y difracción de electrones retrodispersados (EBSD). Los resultados mostraron un incremento en la vida a fatiga para el acero laminado en frío en comparación con el recocido. Este hecho está relacionado con la presencia de martensita originada por la laminación, lo que limita la formación de nueva
martensita durante el ensayo de fatiga. |